The reviews are automatic translation.
Use on a tabletop drilling machine
On 2018-01-22 13:57:38
There was no looseness when tightened, but there was no smoothness as moving as it was tightened. The sliding part of the back surface, grease is painted in the screw and it moves smoothly when it repeats movement and it has come. I think that it can be used normally.
Fix small objects such as bolts
On 2017-04-24 13:31:03
It was better if the rubber was attached so as not to hurt the product in the place to be pinched.
Purchase for cutting work
On 2017-01-31 03:34:38
It is not good to make. Movement such as tightening is bad, it is suitable for the price.
For processing parts
On 2016-03-17 23:53:32
The bottom surface was rattling as you expected, need to be reworked. I think that it can be used.
Connector pressure welding
On 2015-11-05 14:39:46
I chose because there was no groove in the image of the vice's pinching part
On 2015-07-24 15:51:45
Since the bottom surface is not flat, it is used after flattening with a milling machine. Otherwise you will not be able to use it.
Cutting small articles
On 2015-06-08 21:05:34
It is inconvenient to carry with a normal large machine vice but because this vice is small, it is convenient to do a little work in a free place. It may be a firm make for the price. Since there were a lot of garbage around the screw part, I cleaned it with a cleaning agent before use and applied oil for rust prevention, the movement became smooth. It was a dish that I thought would be found more quickly.
Shooting accessories production
On 2015-04-17 15:12:24
The upper part than the V groove in the center is not perfect. Just parallel vertical perpendicular is high accuracy for goods of this price range.
Processing of small members
On 2014-10-21 10:32:27
Machine vice, in general, there are not many cases that doubles as small, so it is almost enough if there is somewhat higher accuracy and higher quality. However, when small objects are hand-machined at hand, and when moving objects frequently, it is difficult to do with large vise. Although I use a small vise, many small and lightweight objects such as aluminum are uneasy and the grasping accuracy is not very good. This product is solid for price and easy to use.
DIY with drilling work etc.
On 2014-06-17 12:24:50
I was surprised by full-scale design, making than by price. A trapezoidal screw is used for the screw, and the sliding surface is also milled. Although the edge of the product is not processed, it is a bit sharp, but if you handle the corner with a diamond file it will not be a problem. I think that it is a product that can be used satisfactorily for professionals.