The reviews are automatic translation.
For drilling at the time of leather processing
On 2017-01-30 15:55:43
The strength of the hexagonal shaft and blade is no problem, but because it was difficult to disconnect is as many blade of Bali, it took a burr sharpening lightly with a grinding stone.
Eyelet drilling of fabric
On 2016-08-18 17:21:57
It is quite a good product. Until now, but is had been drilling in the homemade punch and manual machine, but the fabric immediately blade becomes useless had been cut at will scissors not punched clean, this product, also in impact driver, Mu tabletop it Uchinuke beautiful even in cardboard board.
Soon ... If you see this item
Rubber packing punching
On 2016-08-13 22:57:05
Since it can be rotated, it is very convenient to escape lightly. Because the blade is also thin, GOOD
On 2016-05-18 00:41:20
The hexagon and the punch are connected with the m5 screw. Depending on the ingenuity it may be attached to other than hexagon. As a reference information for those thinking about the same thing, packing production tips are to cut out the outer circumference first from the rubber sheet and then in order to withdraw the inner diameter. I think that the level of sharpness is not very good. I think that this also depends on how the blade is applied, but it is not a complete circle like a ready-made packing but it is very slight, but it gets rough like a bamboo shoot. Grinding may improve sharpness.
I am puncturing the fabric with pressure
On 2015-10-20 16:26:04
Very easy to use.
On 2015-07-15 07:38:20
If it's a small number, it will be tiring if the number increases.
On 2015-02-14 18:48:21
At first I thought it was not going well and thought that the purchase was a failure, but I could open it cleanly if I pressed it quite strongly. I am worried about durability but I think that I will repeat because it can be used more easily than hitting it.
Drilling of vibration damping rubber
On 2014-04-11 21:53:49
I wanted display of hole diameter. I could not use it because I wanted a hole diameter of 10 mm as was also in the review.
Cut the round plate from the resin flat plate
On 2014-02-26 09:08:18
First, outer diameter ≠ hole diameter. There is no description of the hole diameter in the explanation, so if you are purchasing, please refer to the number at the end of the item number. This was also the case with a punch that is not a hexagonal axis of the same manufacturer, so I would like to improve it as soon as possible. Because I think the most important information on punch is hole diameter. I myself bought 8 mm although I needed 10 mm. Also, for my favorite dai tea (Takazaki Gimune) is integrally molded (the hexagonal shaft and the main body are welded), this punch has a hexagonal shaft screwed in (screw shaft). It is easy to disengage when turning by hand, so it is a place where strength is worrisome while using. I will use it by hand if broken. . .