Interchangeable Hollow Punch
* Products that meet your criteria are shown in
- Drilling of leather, cloth, and paper. For leather craft and handicraft, Drilling of leather, cloth, and paper. For leather craft and handicraft
- Hardness HRC
- More than 50
- Weight (g)
- Carbon steel for machine structural use (SC)
- Set Contents
- Hole diameter (2 · 2.5 · 2.8 · 3.2 · 4 · 4.8) mm
Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
3 Customer Reviews
The reviews are automatic translation.
On 2017-05-19 16:27:38
Although it is used for cutting thick paper, nothing can be cut without problems.
Drilling into cord veneers
On 2015-12-10 09:43:57
Originally it is necessary to drill a hole of φ 3.2, but from the cutting edge of the punch to the upper trunk diameter is as short as about 3 mm so that the angle opens with respect to the cutting edge diameter, when φ 3.2 punch is used, the diameter becomes large Pass. Therefore it is good that there is the smallest φ 2 in 7 sets and it is unlikely that the hole opened will be slightly larger even when drilling with this. Hopefully it is good to have a blade length of 3-5 mm with a nearly parallel blade instead of a gradient, relative to the hole diameter of the drill bit.
On 2014-10-30 17:49:05
The sharpness is not good and it was too early to come dull, but suddenly it was enough for just a few times to drill, so it was enough. I think that it is not suitable for regular use, but I think that there is no loss by putting it in a tool box in preparation for Isa.