The reviews are automatic translation.
It is used for grooving when attaching a hinge of a cabinet of a kitchen hanging cabinet.
On 2018-03-16 16:49:44
Well, it is easy to use and cut. In woodworking work, I think that it is an indispensable tool for making furniture etc.
For wood processing
On 2018-03-06 19:10:49
It was sharp, inexpensive, sophisticated with high performance.
I would like to ask again. Thank you very much.
On 2018-02-12 15:46:43
I changed the bit and gradually enlarged the hole, I was able to do a good job as I expected.
On the pillar of a cypress
On 2018-02-04 09:54:23
By cutting it slowly, I could pierce a beautiful hole.
Used to drill the door knob part
On 2018-01-22 15:01:11
I used it to drill a door knob on a solid door.
The size is also perfect.
On 2017-08-11 20:07:16
I bought it a little cheaper than Star M wave cutter and thought that it was better than the home center made in China. Made in China when you see the product. Like the home center, the blades were not sharply cleaned. I tried to drill, but heat and smoke come out, but the cut is not good. Another size Star Mu purchased together was out well. This is good if it is 980 yen in the home center.
Digging of furniture hinges
On 2017-08-10 14:51:13
Depending on the material, there are products that produce white smoke, but it is easy to use and is easy to use.
Bamboo, polishing after drilling of wood
On 2017-07-31 14:51:31
There is no effect at all. Even if it rotates, the polishing power can not be seen. It may be used for soft wood ...
Work digging into wood
On 2017-07-03 05:23:31
Easily, I could dig a very clean hole.
In continuous work seems to be cutting cutting power with a slight heat sag,
It was necessary to dissipate heat, but I did not feel a problem.
"Sharpness good" · · · There is further hope
On 2017-06-19 08:37:00
I am using it for woodworking, but the point that the frictional heat does not rise because the sharpness is good is excellent. However, since the stroke of our drilling board is 80 mm, we can only open the depth to the position of the chuck with small diameter (φ 30 mm or less). At φ32 mm or more, the chuck also enters the opened hole and the maximum depth is possible. I think that a bit with a small diameter needs more length. Because it is a sharp sharpness, I told you a bit of complaints. Someday I would like to arrange a bit of longer if it is sold.