* Products that meet your criteria are shown in table below.
- Suction Power (N [kgf])
- Allowable Voltage Range
- In the case of 60Hz: In the case of 115% 50Hz of rated voltage: 110% of the rated voltage
- Operating Time
- About 0.1sec (at proper load)
- More than 50 million times (according to JIS C4552 solenoid life test method)
- Operating Ambient Temperature (deg C)
- Over 25 over +45 (however that there is no cold case icing / condensation)
- Insulation Resistance (Mohm)
- Koiru non-charge part metal part between 50 or more (500V DC insulation resistance tester)
- Insulation Assortment
- JIS B species equivalent (maximum permissible temperature of 130 degC )
- Temperature rise
- The continuous application of the 50Hz rated voltage in a state in which the movable iron core is in close contact with the fixed iron core, temperature rise 85 degC of fully saturated after coil or less (resistance method)
- Rated Frequency (Hz)
- 50/60 shared
- Withstand Voltage
- Between Koiru non-charge part intermetallic 2000V 1min
- Rated Voltage (V)
- Weight (g)
- 600, (movable iron core) 180
- Stroke (mm)
Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
2 Customer Reviews
The reviews are automatic translation.
It was used in place of turning on and off the shutter of the exhaust of the wood drying machine at the temperature sensor.
On 2016-04-23 18:27:18
It was a coil of the solenoid, which had been using conventional burnt disabled state (30 years use).
Since the manufacturers because it is discontinued Panasonic of those was the same mounting hole size
It was purchased. Wiring is also a simple, two-wire, the movement is also smooth.
Price is also cheaper, it has been pleasing to the customer in the net purchase (Monotaro), so soon get can be repaired.
On 2015-02-06 13:29:05
Broken machine parts, if you find the part number This product was a hit. Stock machine manufacturers were in a hurry without. The price was able to buy for the price of half of the machine manufacturer, come from the machine manufacturers will have the connector is attached to the wiring, [here of the product requires processing because it is without a connector.