The reviews are automatic translation.
We are planning to have switches and controllers
On 2017-05-25 09:21:41
It is cheap and good. The texture of the case itself is not too bad. The speed controller of AC motor is scheduled to be built.
Insertion of electronic circuit
On 2017-05-23 14:58:18
It was just right size. After closing the lid it needed confidentiality and under was enough.
Use by incorporating a dimmer module
On 2017-04-06 18:15:44
While processing was easier because plastic positioning, since post for screwing inside the bottom plate is standing, since the available width than apparent small, fitted with a dimming knob widthwise side surfaces of the substrate are Upon its pillars it was difficult. Since the design is skewed both because the trapezoidal side four sides, use as a built-in case of equipment is a place that one appearance is now.
On 2016-12-16 14:52:05
Good size and easy to use, this quality, is satisfied with this low price.
Used as a self-made controller BOX PC
On 2016-08-17 18:04:35
Size, ease of handling, is satisfied with the weight of both.
Incorporating the base to connect the wires
On 2016-06-23 17:49:27
It can be installed in a narrow place. Drilling is also easy with Holso. I will come in handy.
IC circuit case
On 2016-06-16 19:33:35
It is easy to process and just right size.
It was used for red guiding.
On 2016-02-23 18:54:27
There is neither possible nor impossible.
Small electronic circuit
On 2016-02-14 16:14:43
The evaluation is bad, although a gray color was ordered, a black object arrived. Will Mon Tarou grow up when it grows bigger? I thought.
In a case of a little electronic work
On 2014-10-10 19:37:39
Because it is an ABS resin close to raw (almost no modifier is contained), it is soft and vulnerable to heat. Just touch the soldering iron just to melt it. A boss stands for the screw fixing of the lid quite inside. When you want to put the circuit board etc at the last minute, there is only to remove the boss. I will think of another way to fix the lid. Care is required when using the inner side because the taper that becomes narrower becomes the bottom (the side is not vertical).