The reviews are automatic translation.
On 2016-10-11 21:38:41
Since the old bike is often the gasket is in shortage, we use the drilling of the screw hole part. Are we satisfied with the far sharpness.
On 2016-04-27 00:02:40
Wood, working with the top of the rubber can not be beautiful
Cutting edge is pain in such as iron.
When you hit on top of the aluminum cutting edge also neatly missing not hurt.
The punching of the rubber
On 2016-04-11 15:26:38
We use without problems. Cheap kind was also have deals uniform.
On 2016-02-06 17:51:35
Easy to use, cheaper than other stores. It is Good!
Drilling of gasket
On 2016-01-17 19:20:03
The sharpness of the blade does not seem enough little, in does not open a hole in the very beautiful, because the hole around it would make you stand a little fluff, I'm using it again sharpening sharpen the blade.
Mounting of the towel hanger
On 2015-11-19 20:05:05
Construction was also simple, as expected goods.
Drilling of sheet
On 2015-11-08 20:34:30
The content of the set, but good, none sharpness is bad.
Gasket production of general-purpose engine
On 2015-08-17 05:16:17
Rather bargain than buying separately, is no problem use.
Drilling of the rubber sheet
On 2014-07-27 14:17:55
You can use normally.
However, might this kind of thing's,
Except from the hole (the hole through which the slug) that are vacant on the inside
Note that shifted to the alignment be necessary.