The reviews are automatic translation.
Processing of device mounting hole during machine remodeling
On 2017-12-11 09:40:22
I also wanted a set of preliminary drill, but I wanted a ratchet type handle that was not from the solution in the photograph.
On 2017-10-08 22:40:45
It is perfect. It was better if it was case or boxed.
Female thread processing to brass, aluminum plate, etc.
On 2017-01-21 19:07:50
When you read the review of the other person, you will be worried whether you can fix it properly, but push the M3 tap into the back, you can use the tap of M4 ~ M6 if you fix it in front if it does not have any problem. It may be hard to understand because it is two-tiered.
On 2015-08-26 18:01:01
3 mm tap does not stop securely and can not be fixed. Probably a design mistake? Whether it does not work. It can not be used. Although it is not used except 3 mm, the fixed part has two steps, and seems to be able to fix a large tap.
The tap does not fit in the holder
On 2015-07-31 10:44:47
There is a considerable opening between the size of the tap and holder coupling part between M 3 and M 6, and if it is the narrowest M 3, it can be used without problems, but after M 4 the tap does not fit in the holder. I wanted to use the M5 tap, but I tried hard and it was impossible to try to spread the holder. Monotaro san used it often, but unfortunately the product was unfortunate for the first time.
Correct bolt hole
On 2015-07-06 14:45:15
There is no problem regarding use, but if there is a case to keep it, I am grateful. Because it is a small thing, it seems to be lost ,,
Used for your own aluminum case
On 2014-07-17 16:06:37
Although I only use 3 mm, it is troublesome to cut a tap vertically but it is like this