Buy more than* S$200* and get FREE SHIPPING
Due to the maintenance, we will close our website on June/19 9:00-10:00 and June/23 0:00-0:30 JST.
All customers cannot shop on our website during the time. Thank you.
Grinding welding spot as TS type holding tool of cuvitron
On 2015-01-13 09:34:37
I was worried about the height protruding from the initial grinder cover, but when you use it, the sparks scatter less often and you can polish the surface of the cuvitron TS evenly and you can polish it beautifully.
There is too much height so it will protrude beyond the grinding stone cover and it can not be used. Hitachi will be used in the absence of the cover, even if Makita with 5 mm or more of the grindstone cover deeps 3 mm. If it is too low, you can adjust it with washer, but this was impossible.