Since most kick rubber is not attached to domestic moped scooter, I purchased it. Even if you think that the inner diameter of rubber is thin, you can wear it easily by warming it with heat gun for about 1 minute to 2 minutes, so rubber becomes soft, I think that it can be installed easily. The length was cut off with a cutter according to the kick pedal. When I was kicking, I did not cut into the sole of the shoe so it got easier for the kick.
I try to install the wax used for exchanging the tire, but abandon it because the rubber quality of the product is hard, but if it is immersed for 5 minutes in the boiling water and wears it in the hot state in the kickpetal it will enter easily. When the temperature goes up, the flexibility improves drastically and it is possible to wear on most models. However, recently there are few bikes with kick petals. . .