Buy more than* S$200* and get FREE SHIPPING
Due to the national holidays as Golden Week, we will close 2018/4/28~2018/4/30 and 2018/5/3~2018/5/6.
This may cause delays with our responses. Thank you for your understanding.
Used for CA1PB ZZ. Replaced with the same weight as genuine Durability is no problem so use as a substitute for genuine It is saved because it is cheaper than genuine It is a plane of delivery, although it should have been asked in the same delivery as other driving system products, but only Kore There was no contact, another day I entered the post instead of the courier I did not properly check the inside of the box, but I was also bad, but since there was no contact, I think that it is complete and I open the crankcase I noticed just before it was a dangerous place twice so I'm worried about next shipment as well
I wrote 4th, but it was sending out after 1 week. It was late because everything was shipped in bulk. Previously, although it was inventory, it was canceled as if it was not there, it was informed only by e-mail. goodbye.
It used to be used with high speed pulley Kit was Donpitsari! My weight is 60 kg. The rollers are also 5 g × 3 in KITACO and 6 g × 3 in a total of 33 g, and the maximum speed is 55 km which is the same as normal but the acceleration is surprisingly surprising. (Just fuel mileage got worse enough to surprise but ...) All others are normal, but just by exchanging pulley KIT and rollers, it is so much faster and satisfying.
Up to now I was using 3.5 g about 5000 K, but since the replacement time has come, I changed it to 4.0 g. 3.5 g had quite a bit of vibration, so we thought it would be reduced even a bit and thought 4.0 g was chosen. Weight increase of only 0.5 g, but I hope the balance between acceleration and maximum speed will not collapse!