The reviews are automatic translation.
As a hobby
On 2018-05-16 16:35:45
I tried using the end mill (φ 8 mm) for the first time with a monotaro brand. Compared with MITSUBISHI Hitachi's aluminum end mill, there is a feeling that machinability is somewhat reduced, but because the price is cheap, I think that if durability is equivalent, it is cheap. I would like to use it in the future.
On 2017-10-08 13:18:41
I am using it for processing aluminum.
Chipping is harder than cemented carbide.
On 2017-08-08 14:31:07
Sharpness is very good feeling. It is saved because the price is also cheap.
On 2017-07-06 15:34:21
I think that sharpness was good compared with other manufacturer's products and made a good choice.
I would appreciate it if the blade width is 18 mm with the same shank.
On 2017-04-11 15:38:41
Being cheap, very sharp and well finished are clean. It can be used without problems.
On 2017-04-08 15:01:59
It seems that it is peeled for light cutting, but its durability can be polished so that it is being used with pin angle attention
Cutting of A5052 with CNC
On 2017-03-09 08:37:09
Several pieces were used but the sharpness was not good. It fuzzs and is rough. Compared with other companies there is no sharpness on the side blade. Hitachi is absolutely better although there is a little price difference.
Aluminum processing by NC machine tool
On 2016-09-26 10:16:57
Although sharpness is good, holding of a blade is very bad, sharpness falls and it breaks at its worst. It is best to replace when sharpness comes down, but the replacement cycle is very short, so I feel like the end mill does not differ from the ordinary end mill in terms of cost ...
Plastic cutting processing
On 2016-08-02 18:55:52
Because it was used in plastic cutting, it can be cracked crisp. Wear of the bottom blade was slightly early, the facial aspect was not so good
On 2016-05-26 16:28:12
Although other companies are too expensive, they are tolerable. The difficulty of sharpness sharpness is that it is possible to cope well and cut down costs as long as polishing tip