The reviews are automatic translation.
Wheel bearing part of mountain bike
On 2017-05-19 20:06:28
It is also a good performance compared to manufacturer genuine products. I will also purchase it.
Road Bike BB
On 2016-06-01 14:34:38
Buy for BB of road bike.
Is a normal 6806LLU.
It does not even dare bad.
As head parts bearing the Pinarello Dogma 60.1
On 2016-01-13 21:09:42
Size is not usable without a problem because it is the same. In addition, it does not feel affected by the handling in contact seal.
Maintenance of vehicle
On 2015-11-04 17:48:02
It can be used with confidence because NTN product.
Exchange of road bike of the bottom bracket
On 2015-10-14 21:14:45
Purchase bearing the exchange of BB30. Still it is no NTN rotation smooth and complain of domestic. If replaced with beans that maintenance is not needed, such as a ceramic ones.
Repair of machinery
On 2015-08-05 07:22:56
Yes are also available to obtain hard to count of bearings we are grateful.
Address V125G driven
On 2015-05-22 16:09:03
It was purchased in leveling exchange-driven address V125G. Genuine will close 1800 yen will be saved can be found at less than half.
Used to BB30 of bicycle
On 2014-10-03 18:03:27
The BB30 bearings of Cannondale to Gorigori in to about 2000km to the ceramic. Cleaning quite frequently, but had been grease up, exchange did give up from here to the domestic bearing. Disposable at this price is also OK if the. A feeling of use is smooth, precision was also down pat.
Also I would like to buy!
Hub bearing of a bicycle wheel (road racer)
On 2014-08-24 16:38:32
I do not mind specially, but it is a good degree of accuracy because it is bearing of the Japanese manufacturer.
Road Bicycle BB 30 Bearing Exchange
On 2013-11-18 19:25:19
Road Bikes BB 30 Bought for bearing exchange. Because genuine products are made in foreign countries and the price is high, NTN made bearings were substituted. I feel that the feeling of use is more stable than the genuine product, also the rotation performance. I do not know yet because I do not use the endurance, but I think that it will be fine for 2 to 3 years. Bearings should be made in Japan.