The reviews are automatic translation.
Formals line winder (homemade)
On 2017-02-13 15:34:49
φ12 was purchased for the axis, but a smooth slip, can be satisfied at a low cost if used for light load. (However, φ12 shaft that was purchased at the same time (the hollow CN axis) for that contained the burn on the surface, could not additional machining. Caution)
On 2016-11-29 18:53:41
It looks at first glance cheesy, but us with the necessary minimum work. Since the cheap was saved.
Matomarimasu to use small size in the bearing.
On 2016-08-26 16:29:01
Us to move smoothly without stable lubrication.
It was used in the home garden sieve table
On 2015-09-28 22:51:19
It was fitted with a two Minipiro to sieve table previously.
Two further added where movement now has satisfied becomes smoother.
Of the rotating shaft support
On 2014-10-27 19:18:15
It is surprisingly friction loss is large.
The sound also is not quiet.
Bearing unit tried to buy to try here because it is not only a big thing of more than 12 mm.
Cheap price of'm glad.
Maintenance jig of the wheels
On 2014-09-07 17:14:24
Rotation, etc. There is no problem.
It did not match to my intended use.
But we were going to rotate use the SUS of the shaft
Rotate the load is thought takes was not obtained by my selection mistake.
The following is, I think that you want to use the UP000.
Link of the lever
On 2014-04-26 23:41:33
This unit is likely thing to use not secure the pyro and the shaft, use the ones that contains the bearing is always around and that point.
Slide of the shaft
On 2013-06-08 01:14:08
I was looking for a bearing to slide the shaft.
There is plenty if you just rotate, but we slide also make it possible addition at a low cost can be manufactured the machine.
I think that it is very good commodity.