The reviews are automatic translation.
On 2017-04-16 01:12:01
SUS304 cutting of
On 2017-03-08 20:04:52
0.8mm So, off well, wear that fast is the same as the third-party products.
Since the cheap price, the cost performance is good.
SUS430 thickness 1.0㎜ cut
On 2017-03-02 20:22:30
It is stainless steel processing shop of this road 40 years. The company is of stainless steel cutting grindstone 3.5m cut in the can a stainless steel plate is this cutting grindstone fall by the wayside and severe exhaustion. Price is deplorable is the short cut possible length to high. Where Will the benefits of this grinding wheel is there? It would be good even if the people do not use only occasionally, but do not think only the bad products are for those who use every day. The future will use the stainless steel cutting grindstone of the company. People here are by far can trust.
Cutting or corrugated plate, cutting or deck, to the cutting of thin aluminum.
On 2016-12-05 14:31:08
So, it seems to be good.
It sharpness is good, a straight line is, it seems so easy to take.
Still, I began to use, we hope in the future, I want you to success.
When machine maintenance and material processing
On 2016-11-19 13:26:43
Previously, I think that it is products that can be enough to convince if this price to but both use impression sharpness was using Thunderbird 0.8.
Steel cutting, etc.
On 2016-11-01 11:35:52
You can use without any problems.
I think that is less chipping than those of other manufacturers.
On 2016-10-28 11:53:11
This is pretty good.
Less difficult cheaper to cut crispy.
And repeat purchase.
On 2016-10-14 18:01:55
Well you off, it is satisfaction. Price is also the performance is also not a problem
Cut the material
On 2016-08-05 11:12:59
Although I used a thin blade of 1mm until now, work efficiency went up because the people of this product is a good sharpness.
Cross section was also beautiful than the thin blade of 1mm.
During the cutting
On 2016-07-16 17:19:45
Since the following of teeth was not much 1mm, using well when you want to keep as much as possible the material.