The reviews are automatic translation.
Assembling the machine
On 2018-02-01 21:09:07
Ideal for perpendicular drawing of machine assembly.
As a machine shop does not make a mistake,
Please buy one with the front and back mm.
It is used for checking machine assembly and piping work.
On 2017-09-03 15:33:48
We measure it because it is often used to measure the dimension from the edge of a right angle. It is very helpful to have memory both outside and inside.
On 2017-04-18 16:09:37
It was very easy to use in a place with small weight and size.
On 2017-01-23 19:20:26
Until now I used only fingering rectangles, but I also often think that if I have Soya here. . After all buying correct answer! Easy to use, I think that Cinzpa is good for this product of Shinwa. The correspondence of MonotaRO was also good.
Skeleton of steel frame material
On 2016-02-05 21:58:00
Because it is lightweight and compact, it is easy to carry in a working waist bag.
Control panel etc. Production
On 2015-12-28 15:36:32
We are using it for scoring work of the hole opening position at the time of production such as control board. I will be saved if it is a bit cheaper.
Measurement of construction site
On 2015-04-28 05:20:37
Everyone uses it at the construction site. It is easy to examine the right angle rather than the deposit, it is convenient without breaking even if it treats roughly. At the factory, I'm using a stop type Soya, which is a bit bigger.
90 degree check when bending iron plate
On 2015-03-02 20:55:37
I am accustomed to this and regularly buying it.
On 2013-05-19 18:08:54
I used the same thing from before. I chose this without hesitation again this time
Right angle inspection, scribing
On 2013-04-07 03:03:31
Usability is pretty good with graduations on both sides and inside and outside. There is no problem with right angle precision, and although it is used frequently, rattling and bending have not appeared so far.