The reviews are automatic translation.
DIY jig creation
On 2017-05-17 18:42:45
I used it for drilling a 5 mm thick stainless steel plate. It seems that it is a little thick, I felt 3 mm thick is appropriate.
Drilling into stainless steel door
On 2016-10-25 16:42:27
Sharpness is good There is only well-known manufacturers products. I think that a little long the center drill.
Drilling of steel (4.5mm)
On 2015-07-08 20:44:59
I drilled holes in 10 places of square steel, how likely go hole saw yet, how has fallen off the center drill. I bought one to spare is likely settled without for a while.
On 2013-07-18 13:11:01
Because the price was cheap, I was wondering if I could not cut it much, but I am satisfied with the sharpness also for the price.
I installed a hole in the stainless steel top board to attach the alkaline ion water conditioner to the sink.
On 2012-05-02 14:52:40
I could drill without difficulty. Speaking of greed, it was the best if there was enough depth to drill a reinforced plate under the stainless steel plate together. I could not penetrate because the upper side of the cutter was wider.
Perforation of 2 mm stainless steel plate
On 2010-10-04 16:09:30
In the drilling of 2 mm stainless steel plate, it is difficult for inexpensive carbide cutters and bimetals to be inadequate, and again it is difficult unless it is of this class. As expected there are only maker items, it is expensive but it will expire well.
On 2010-06-21 08:18:08
Drilling of stainless steel plate
On 2010-01-30 14:54:31
It is outstanding sharpness that there are only maker items. Even cemented carbide is a stainless steel opponent and it can be used only a few times, so it will be nice to be a bit cheaper.