Attached to a gyro canopy that can not install a smart holder at all, such as a handle bar. Remove the inner cowl of the handle, drill a hole in M8 (mounting hole of the clamp bar itself M10), prepare the bolt and nut, attach it to the inner cowl and finish. There was no particular problem. If you say it daringly, I would like you to turn on the bolt nut set for installation ...
It is used in joint tightening to the rearview mirror of the bike.
From Japan
On 2017-02-08 09:24:28
1, I want the round bar to be a little lighter. 2, I would like a painted hexagon nut as well. 3, Since it is a nut stop, it moves in the front and back, but it is only necessary to adjust the vertical direction.