Two-sheet of blades MSTAR end mill (M) MS2MSD0400
- Package Qty.
- Ship pack of
- Helix Angle (Degree)
- Edge Type
- Pin corner
- General Purpose
- Tolerance (mm)
- -0.015 - -0.038
- Blade Length ap (mm)
- Overall Length L1 (mm)
- Number of Blades
- Surface Processing
- MS coating
- Ultra fine grain cemented carbide
- TRUSCO Part Number
- Shank Diameter D4 (mm)
- Blade Diameter D1 (mm)
- Work Material
- Carbon steel, alloy steel, cast iron and pre-hardened steel and hardened steel, stainless steel ,titanium alloy and heat-resistant alloy
Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
7 Customer Reviews
The reviews are automatic translation.
Pattern manufacture of electronic circuit board using NC engraving machine
On 2015-09-14 15:09:33
Is the impression of the individual, but this end mill was easy most use.
I do most long-lasting to. I'm going go with this in the future. Please do not to handle stop.
On 2015-07-21 08:43:22
During drilling, burr comes out but little.
On 2013-01-16 13:59:51
Like the time being good. I want to use a little more.
On 2012-10-07 12:16:08
Because there is less chatter in sharp sharpness is good.
Thin cutting of acrylic (t1.5-t3)
On 2012-08-24 05:10:54
Us we are made of a cutting of acrylic. Since the deal's is only just thin, was changed to as short as an effective cutting edge length, the life of the tool grew by leaps and bounds.
That was about 30m up to now, has been stable and shaved more than 100m.
It prefers to turn to use a cheaper tool cost can be suppressed, but you have chosen here from stability.
On 2012-05-21 13:36:44
So so good to have.
Used in artificial marble of acrylic
On 2012-03-05 20:15:05
You can use Well Well
Customers Who Bought This Item Also Bought