NoteBuy more than* S$150* and get FREE SHIPPING

  • Hand Nibbler

Hand Nibbler EA627AC

1.67 (3)
Package Qty.
Ship pack of
94.87 SGD
Shipped after 2016-10-24
Now we ship to...
...see all
Item Feature
Grip color may change from RED/Black to ORANGE/BLACK without notice.
Cutting Capability (mm)
(Stainless steel plate) 0.8, (copper, brass) 1.5
Overall Length (mm)
Blade Width (mm)
Weight (g)
Customer Reviews
5 star 0
4 star 0
3 star 0
2 star 2
1 star 1
Review Rating: 1.67
3 Customer Reviews
The reviews are automatic translation.
Additional processing of sheet metal parts of the prototype
From Japan
On 2014-08-17 15:33:35
1. The material was additionally processed: stainless steel plate (equivalent to SUS304) Thickness: Teflon processed parts to 0.8mm 2.200mm 90mm center to the bent angle shape at R5 of, tried to 200mm → 180mm about 20mm width cutting. Result: Handonibura over specifications, stainless steel plate 0.8mm Max. Challenge to the limit? This time, I can be processed without any problems, the notes are described below. ① the first cut at the time (about 2 ~ 3mm) experience an approximate load was applied to the handle in the store. ② about 3mm strip of cut debris that can by cutting enters the groove of the processing on the small bent and female, become firmly at once, maybe this leave the handle press strongly when the blade is damaged, cut strip of the tip of the destination is the destination in such things of a flat-blade screwdriver so as not to be disturbed can smooth the progress cut and I'll make in free. How to use ③ tool? Constantly monitors the state of the cutting edge, if you suddenly load is heavier impossible to, investigate the cause without increasing the load on brute force, why was heavier? --- This point, it is "how to use the fool and scissors". * I ordered the blade at the same time, but I did not have to use this time. However, is the type of clearance of the male blade and the female is better feeling small? Blade: 2.7mm die: 3mm gap 0.15mm → <0.1mm
This review is about item#03545385.
Metal, hollowed out of a non-metallic
From Japan
On 2014-07-12 10:57:02
Teeth horrifying When I tried to cut a stainless steel plate 0.4mm. Useless. You can only place scratch. Stainless steel such as cutting please do not write.
Sheet metal of the car
From Japan
On 2014-04-01 08:23:11
Work start in the hope, the blade was broken in the place that was holding three times. How to use and was not good. The target is around the hole rusty of the body. I wonder if I should have also blowing in the lubricant spray. In place of blade single \ 1,730 ... (TT)
This review is about item#03545385.