The reviews are automatic translation.
Maintenance of car
On 2016-10-20 18:55:59
Rusted internal thread is satisfactory City becomes beautiful.
On 2016-05-23 16:23:15
Clean off with a very small force.
Strength is weak.
Simple resin material processing
On 2016-03-14 14:45:50
In the processing of the resin material, we were able to proceed without any particular problem.
Sigma Koki, etc. for the optical bench production
On 2016-01-31 20:17:08
I think that anything or used if the tapping of M16X1, but we are tapping of M16 that are open to the optical bench, such as Sigma Koki has used this tap. Sequel: (!), But was introduced by facsimile from later was heard in the chat support the M6, want is was this.
Used for simultaneous biaxial tapping process of brass and curable resin
On 2015-10-23 18:37:48
We are using it for tapping process with 2 axes at the same time to brass inserted in thermosetting product. Because the product hole is stopped, the tap tip is used by scraping it flat. The one I bought this time was for the second tap so I will consider raising taps next time. Furthermore we catalog. Raising tap product verification was not possible.
M12X1, 25 tapping screw
On 2015-08-11 06:41:17
The screw part of the nut was corrected with M12X 1, 25 tap (YAMAWA). Very sharp. Although the price side is a little expensive, I would like to use other sizes.
On 2015-02-20 21:56:41
There is neither good nor bad for processing by a single item
Tapping of aluminum servo horn
On 2014-05-13 19:34:28
High accuracy tapping is possible. M2.5 is thin so be careful not to break, so be careful.
Screw faced assembly work during staircase production
On 2012-02-19 12:46:37
I also used taps from other companies, but the tap of Yamawa is very satisfied without a break even though it has a long life. It is truly a Yamawar. I think that work also goes up and cost performance is also excellent as a result.