Metric screw for stainless steel tap point SU-PO P4 M12x1.75
SU-PO P4 M12x1.75
Ship pack of
Dimensions k (mm)
Shank Diameter d (phi mm)
OX (oxidation treatment)
Dimensions l2 (mm)
Number of Flutes
Dimensions Lk (mm)
It becomes a protruding center at below M6.
Vanadium high speed steel HSSE (high speed steel)
Screw Length l (mm)
Female Screw Type
Metric screw threads
Overall Length L (mm)
Number of Chamfered Threads
TRUSCO Part Number
Grade of Female Screws
6H, OLD JIS LEVEL 2
Usually used for passage holes.
Compatible Machinability Material Types
Low-carbon steel, mediume carbon steel, stainless steel
Customers Who Viewed This Item Also Viewed
9 Customer Reviews
The reviews are automatic translation.
On 2017-01-23 08:56:27
Because it is purchase by part number designation, it is satisfied because it can buy it cheaply earlier than other stores
On 2016-10-20 22:13:31
There is no problem sus we are using.
On 2016-03-12 06:09:50
Threading to SUS303t30
On 2016-03-09 17:55:58
Those of other companies ordered earlier were able to lack tap tips and changed resistant during processing so that they could be used without problems using Yamawake
When re-tapping, when turning with forward rotation and pulling out with negative rotation Last broken at 4 mm of the last edge and in the second one
On 2015-09-22 14:50:04
It happened that the item was bad. When you can break, it's time to pull out, it's hard to pull out, so do not retry, spiral tap cutting might be easier to remove.
Tap processing to thin plate
On 2015-04-18 10:21:53
Durability is also used without problems.
On 2014-03-12 10:47:39
Until now, it is cheaper than the tool shop you purchased.
Tap to FB bar
On 2013-05-28 15:15:23
I worked on the same conditions with OSG and taps from other companies, but I had a longest lead. OSG lacked the tip.
I use it for the street hole of SUS 303.
On 2010-03-07 21:36:25
Successively I cut about 20 20 mm screws, but I will not go back at all.
Customers Who Bought This Item Also Bought