The reviews are automatic translation.
For Saraje at reassembly
From Japan
On 2018-03-13 18:32:04
There was only a major manufacturer and I was able to work reliably.
Steel fitting replacement work
From Japan
On 2018-02-08 18:19:45
Up to now, I've done tap opening with handwheel, but after opening a pilot hole with a drill, I will enter with a power tool, very efficient.
I am using it for screwing the stain
From Japan
On 2017-02-22 04:21:59
Kiriko climbing well and cutting resistance is also small so it is a tap that cut well without imposing excessive opportunity
M.2 For securing the aluminum heat sink of the SSD
From Japan
On 2017-02-14 18:08:47
When placing a 2 mm screw on aluminum, it was broken if it was a normal tap, but this is a good drain of chips and there is no worry about it.
Drilling of stainless steel
From Japan
On 2016-11-20 04:38:30
I also want to purchase it because sharpness is good as well as kiriko's brushing is also good
Hobby Craft
From Japan
On 2015-10-16 19:48:02
Also sticky material such as stainless steel and aluminum can be sticky threads clean. I replaced all the point taps I owned with a spiral.
Thread cutting
From Japan
On 2015-09-08 19:35:33
I could cut the screw without problems.
10 mm stainless steel ○ Add a groove of about 5 mm to the rod
From Japan
On 2015-02-01 09:34:51
It broke with use of about 5 mm to 4, 5.
Tap stand for 9 mm stainless steel plate
From Japan
On 2014-10-20 15:41:45
I am happy because I can tap work easily with a spiral tap
Tap work
From Japan
On 2014-08-15 20:16:20
Easy without tapping spray