The reviews are automatic translation.
Drilling of the insulation panel
On 2016-08-06 16:55:20
Well it has expired. We were able drilling without any problems. Cutting debris if there is a spring I may not clog large minute diameter only effective short amount than the length of the hole saw (part of the interior of the core is sticking out toward the cutting edge) Noto base is reinforced because through work is 100 points on our side, because I think it is a fire ant whether is cruel to ask up there for this product.
On 2016-05-24 10:23:42
Is good cheap and very workability.
Drilling of iron
On 2016-05-18 08:42:30
it is good.
Drilling of thick iron plate
On 2016-04-17 13:26:53
Than I thought also, sharpness well, personally I like than the chip hole saw. Sharpness as well, and quite long-lasting. 32 mm thick steel plate was also seen apart from the ins and outs.
Thick flat bar drilling
On 2016-03-02 18:16:02
Iron plate of 10mm thickness if slowly the feed using the cutting oil by drilling machine was also possible through somehow, cutting edge fly if the impossible.
It is drilling for mounting the sink faucet fittings
On 2016-02-14 23:21:58
Cut out material the spring is attached to the center will take off easily
Aluminum plate processing
On 2016-01-07 23:09:30
It was used for the drilling of the general purpose of the aluminum case. Sharpness is often great to cheaper than those made by other companies, which had been purchased at home improvement until now.
Durability does not know yet early days for, but also I think to buy.
On 2015-12-22 11:10:10
Easy hole is opened
Metal and wood processing
On 2015-12-19 15:25:16
Durability is decent. If you do not use unreasonable to, I think that it is quite good.
Wall, or Install the plug on the floor
On 2015-12-10 19:26:21
Aperture setting is no choice for the 60Φ. Easy to use.
But hardness is it not much.
Only cutting edge may be Kaikaere After getting less.
Price There is also affordability in its own way.