The angle of the lower part of the included blade and the cutter body is different and the blade is attached obliquely. Although I could cut the lower part of the body by myself and set the angle straight and install it straight, I feel that it is better to improve this.
Very easy to use. While also looking sharp, grips become familiar with hands and are less tired. It is good to choose colors and it is cheap so buy a couple of items and conveniently put them in all the tool boxes. I can not use a cutter knife anymore. Speaking of the difficulty, you can not use the storage space if you buy the back of the main unit. Just keep in mind just putting it in, it is dangerous to take out again.
It is used for pattern cutting of printed circuit boards and removal of resist.
On 2011-02-03 11:18:26
It was familiar to the hand and it was very easy to use as expected. There is a replacement blade in the main body, but taking out is a bit scary (T_T) I felt cost efficiency was high with a lot of replacement blades in it.