The reviews are automatic translation.
Used in sculpture.
On 2016-06-01 21:37:02
You come in handy in fine sculpture. It carved used properly with the blade end blade there.
It is like those of the cross-cut bite is good.
Details deburring of stainless steel products
On 2016-05-15 22:18:41
Cheap, but there is no brand products and inferiority
Aluminum, zinc alloy, plastic, cutting of wood
On 2015-06-10 15:37:57
Bite of the blade will not use the center a good spiral cut. It is likely impression sharp-looking. Rust hardly sharpness will be long-lasting. End blade is useful. If it is something that can be successfully cut the nylon, it is even better, but ....
For a cutting from FRP aluminum, iron
On 2011-12-06 22:55:40
Tools of this kind, there are many things that scraped well and as hard as carbide and the name stuck.
However, it does not last long (the poor have) you there are many.
Those that have been used previously, did not burn even if the hard and good retention is also well impossible.
I was looking for the same thing, but the thing here is I bought it is determined that looks good.
Very hard cutting performance is a feeling that I have used is also very good.
If you continue to use long-term final evaluation can not, but I think that it is a tool that can be expected.
Cutting of aluminum by mini router
On 2010-11-02 15:33:02
Cutting bit is a wide variety in the price range of mini router is also wide, but there are also some of the blade is weak and often caught while referred to as cemented carbide is in. Because of this product is the cutting surface of the cross-cut, without that the blade is dull, chips are finely ground, the operation is effortless very easy to use is good.