The reviews are automatic translation.
As a snap ring
On 2017-03-24 17:17:08
There is no problem as a snap ring. In addition, Buy
Use the RC def
On 2016-04-06 17:06:09
Smallness of the hole is odd not, I did not pass through the tool of KWT that has been used until now.
I had been in and out of the snap ring of the same 8mm.
Forced I purchased a tool Knipex.
Still, it is a thin meat in the vicinity of the hole. Only to the locations to use in response to the thrust bearing
Strength is worried about.
On 2015-12-19 19:17:05
This consent refreshing new goods exchange. Price You can also use cheap to normally. It is should be noted that good the less a little lot.
On 2015-12-10 21:15:40
It was a good article
I tried to use it for a linear bush
On 2015-02-01 15:57:28
I bought it as a part to be fitted in the groove of the linear bush, but if it spreads it will be damaged so if you check with your company it was a completely different product. Era of ignorance of human beings to buy the net, I wish us a little more clearly. The remaining 53 pieces can not be used. (Oh waste.)
To a motorcycle
On 2013-07-25 13:12:39
I use it for the wheel bearing of the motorcycle
On 2013-01-05 12:36:37
Although it is Osaka soul brand, it was confirmed that the manufacturer could confirm with the product photograph, so I could buy it with confidence. When the pliers hole cracks, it is a part that becomes difficult to remove, so I will search with quality emphasis rather than price, but the price was also cheaper than other brands and satisfactory goods. As PB, I think that there are times when manufacturers may change, but I would like to disclose information to consumers even a little.
Agricultural equipment repair
On 2012-09-13 23:55:33
The strength of the spring is optimum, and there is no deformation even when tightened with a snap ring pliers during installation. Also, even if you hit with a driver for driving, there is hardness that does not get scratched, so it is very easy to work and there is a sense of security.
Machine parts installation work
On 2012-07-12 13:07:36
I used it normally.
As a part for experiment.
On 2012-06-30 23:36:21
If the dimension (d 0, the diameter of the smaller hole) is R-8, it is written as 1.2 mm, but it seems that it is close to 1 mm as measured by scanning. Because I bought it for the purpose of experiment which is not the original usage way personally, I've used the satisfaction level normally.