The reviews are automatic translation.
As a snap ring
On 2017-03-24 17:17:08
There is no problem as a snap ring. In addition, Buy
Use the RC def
On 2016-04-06 17:06:09
Smallness of the hole is odd not, I did not pass through the tool of KWT that has been used until now.
I had been in and out of the snap ring of the same 8mm.
Forced I purchased a tool Knipex.
Still, it is a thin meat in the vicinity of the hole. Only to the locations to use in response to the thrust bearing
Strength is worried about.
On 2015-12-19 19:17:05
This consent refreshing new goods exchange. Price You can also use cheap to normally. It is should be noted that good the less a little lot.
On 2015-12-10 21:15:40
It was a good article
I try to use a linear bush
On 2015-02-01 15:57:28
It was purchased I think that parts fit into the groove of the linear bush, but it was totally different commodity Once you have verified your company because the damage to extend.
Era of ignorance of human beings to buy the net, I wish us a little more clearly.
The remaining 53 pieces can not be used. (Oh, shame.)
To a motorcycle
On 2013-07-25 13:12:39
I use it for the wheel bearing of the motorcycle
On 2013-01-05 12:36:37
Although it is Osaka soul brand, it was confirmed that the manufacturer could confirm with the product photograph, so I could buy it with confidence. When the pliers hole cracks, it is a part that becomes difficult to remove, so I will search with quality emphasis rather than price, but the price was also cheaper than other brands and satisfactory goods. As PB, I think that there are times when manufacturers may change, but I would like to disclose information to consumers even a little.
Agricultural equipment repair
On 2012-09-13 23:55:33
The strength of the spring is optimum, and there is no deformation even when tightened with a snap ring pliers during installation. Also, even if you hit with a driver for driving, there is hardness that does not get scratched, so it is very easy to work and there is a sense of security.
Machine parts installation work
On 2012-07-12 13:07:36
I used it normally.
As a part for experiment.
On 2012-06-30 23:36:21
If the dimension (d 0, the diameter of the smaller hole) is R-8, it is written as 1.2 mm, but it seems that it is close to 1 mm as measured by scanning. Because I bought it for the purpose of experiment which is not the original usage way personally, I've used the satisfaction level normally.