The pack twist drill for ironworkers SDXJP 4.1
Ship pack of
for machining of Mild steel, cast iron, aluminum, copper, plastic and lumber
Point Angle (Degree)
Flute Length l (mm)
JIS STANDARD PRODUCTS
Blade Diameter D (phi mm)
Overall Length L (mm)
Customers Who Viewed This Item Also Viewed
9 Customer Reviews
The reviews are automatic translation.
When drilling work
On 2018-02-18 01:38:56
It is cheap and there is no problem with quality. I always buy this item.
For Threading Pilot
On 2017-12-04 17:11:48
It is a drill for ironworks, but because it is affordable, it uses aluminum and woodworking as well as anything. Sharpness is good.
Drilling of ironworking relation
On 2017-08-14 23:57:06
After all, it is Good made in Japan HC's cheap blade breaks as soon as the bending force is applied. That point was tough.
On 2016-06-30 16:08:27
No particular problem
Drill a hole.
On 2015-09-22 00:40:45
Even though I am deeply impressed by the usual sharpness, I can do my work indiscriminately without anger.
Pilot hole processing
On 2015-08-03 15:45:27
Pre-hole drilling before reaming
On 2015-01-18 22:44:38
Nazi products are sharp and last long. I will continue to use it from now on
Ironworking work at the atelier
On 2012-09-24 15:11:38
As a drill, it is a standard that can be said as a standard, so its quality, cost performance is reliable. Also thinning, it can be said that it is necessary enough.
On 2012-07-03 16:07:42
Because Nazi products are always used, I purchased without hesitation. Normally I change the shape of the cutting edge for woodworking, but even if I use it for wood as it is, I am able to process it cleanly.
Customers Who Bought This Item Also Bought