The reviews are automatic translation.
Hole drilling of stainless
On 2017-01-05 16:50:14
We use the lower hole of the reamer is difficult or flow has may be good linearity
Mainly iron, copper alloy drilling
On 2016-11-29 14:50:57
Relatively inexpensive and carefully use and there is also a durable, good enough for general use.
M5 in for the lower hole of the tap
On 2015-10-14 16:53:16
Because there are a lot of screw processed into aluminum material, we used an inexpensive this product.
Perhaps because of changing the drill chuck to those of high-precision, drill has made accurate drilling without blurring at all.
Drilling of screw holes
On 2015-02-25 10:58:51
Yes without any usually without any improper.
Drilled in a plate of SUS
On 2013-11-18 21:32:46
An attempt was made to drilling to 2mm SUS plate in the drill teeth of a hand-held electric drill + titanium coated with amateur DIY, but it takes an hour, yet the position of the hole is gradually I have also shifted 4mm.
Half to give up, I tried to use to obtain the product of stainless steel only, not less than five minutes, we were able drilling To crispy. It seems to be baffled.
If you use a good tool you can good job. Please try.
Under hole of tap
On 2013-05-16 16:12:56
Is no problem
SUS plate is drilling
On 2012-11-21 13:17:35
I will continue, the quality is, but if you can work hard a little more price of course
Competitors price on the net also we think that you will not be able to bother me.