The reviews are automatic translation.
On 2017-02-13 22:58:16
I did not know the name of the product, but I was surprised to find it smoothly. The price was also cheap and it was saved.
To fix the rotating shaft of the engine mixer
On 2016-12-27 19:31:38
We used multiple screws for repairing the screws because the male screws on the rotating shaft were damaged during the overhaul and the screw threads were able to be restored. There was a long use.
Used when replacing bearing bearings
On 2016-08-12 05:36:58
It was able to be used without problems. Although it is not a frequent replacement, the price is also cheap, I am satisfied.
On 2016-02-22 23:14:47
It is very good workmanship.
For checking the thread of the production shaft
On 2014-08-22 08:56:04
It seems that it can be used as a new nut, gauge
Tightening up thrust bearing of camshaft of automatic cam lathe
On 2014-04-21 11:00:34
It is a commonly used bearing nut. Even if it is used, I do not seek it, but I think that the finish is beautiful and good. Performance against price is sufficient.
On 2014-03-03 19:48:35
It was able to be used normally. I am satisfied.
As a part of prototype
On 2012-09-07 15:22:54
As I was looking for parts of prototype, I was in Monotaro who I always use. When in small quantity the price is reasonable and it is saved. It would be good if the amount to be free shipping would be a little lower if possible.
On 2012-05-31 12:18:29
MONOTARO brand was made in Korea, finish of details was not good, but this was made in Japan and the finish of the screw part was also necessary enough.