The reviews are automatic translation.
On 2016-11-17 21:10:32
Excellent cost performance, inventory, assortment may also be rich.
For communication equipment experimental measurement jig
On 2016-11-16 10:40:02
It was used as a ground connection between the coaxial connector mounting substrate and the copper foil. Conductivity, adhesion and also without any problems, we are satisfied.
Use on a jig
On 2016-09-29 16:32:10
Conductivity can also be used without problems.
As a masking tape in an aqueous solution
On 2016-07-07 20:28:20
The strength of the tape is satisfactory, but there was a difficulty in use by many penetration in applications as a masking of the considerably weaker in the aqueous solution than those which the adhesive force was expecting. I was expected because there is a continuity, but has determined that the unreasonable use of this application.
Repair of the film substrate of the keyboard
On 2016-01-16 20:30:36
That the pattern of the film substrate of the keyboard has a break was repaired in this conductive copper foil adhesive tape. Conduction of pattern disconnection unit has recovered.
This tape has also 20m length, as there is also the other people reviews, I can say convenience is also there and a small amount of the intended use things a little more short.
Repair of sheet type of wiring
On 2015-07-20 22:24:21
Part of a printed sheet according to conduction paint had been degraded by moisture. Used for repair of this part. Since the adhesive portion also there is a continuity, and fully to fit the width of the line, conduction recovery only paste. It is quite convenient.
A little more, if there is a small amount (short) type, also I may usability and convenient to carry, and the like.
Noise measures of control cable
On 2014-03-14 16:17:39
I was looking for those of 25mm width. Since COSPA also good I think that to repeat.
Film foundation disconnection repair of children's toys
On 2013-10-14 16:39:53
It was purchased in order to repair stretched from the top to the disconnection of the film foundation of a toy, but it does not energized and not the adhesion quite pressing to cut thin because disconnection surface of the base is small. We want to increase the electrical conductivity or adhesive force of a little more adhesive. The monetary value is very happy, but the amount (length) is not so much need. Enough so if there is a length of about 30 centimeters is happy when there is that much of the product.
Electronic equipment of shield, GND auxiliary
On 2013-06-14 14:07:27
Is profitable cheap unit price than those sold at the electronic board shop.
Such as ground reinforcement and noise prevention of wireless system
On 2013-05-14 13:19:27
Adhesive force than I thought also was easy to use high.
It was usable without any problem because the solder also was easy to ride.
But will the surface oxidation because there is no coating in the outdoors
Ginger not I think.