Buy more than* S$200* and get FREE SHIPPING
Due to the maintenance, we will close our website on June/19 9:00-10:00 and June/23 0:00-0:30 JST.
All customers cannot shop on our website during the time. Thank you.
By heating up the connector tube with a dryer, the tube will shrink because of the heat and protect the connector. By heating up the connector tube with a dryer, the tube will shrink because of the heat and protect the connector.
Shrinking Temperature Start (Degree C)
About 2: 1
Inside Diameter (phi)
Before contraction 5.6+/-0.3mm
After contraction 2.9mm
At the end of the covered wire, the copper wire is exposed and there is a danger of a short circuit. It is okay if you use this. When you stroke with a soldering iron it shrinks quickly. It is perfect if you can stroke from 4 directions.
I connect the 110 type flat terminal to the power relay terminal but if it is a cover for a flat terminal it seems to be next to each other bulky so I replaced it with a shrinkable tube, it was made with a 5 mm diameter tube, but it was thinner The tubes may fit each other.