The reviews are automatic translation.
When the dimension measurement of the product
On 2016-12-21 16:44:30
Although we used a competitor's product for the size measurement of the product,
Cost change to the above has dropped significantly.
Measurements of dimensions
On 2016-08-17 17:27:03
When reading the scale of 0.1mm, large gap of overlapping lines, can not be confirmed. Tolerance, and it is ± 0.1, you can not use.
Used for processing of automobile and bike
On 2016-06-27 19:20:39
Mostly of special work will be carried out I, have come in handy, such as a fine size. Also it has been firmly in Monotarou brand.
During product processing
On 2016-05-30 09:11:22
And those of other manufacturers, accuracy is also unchanged, so was able to buy cheaply, we are satisfied.
On 2016-05-05 07:06:24
There is no problem in particular. Much is inconvenient to immediately housed cracked claws of the box.
On 2016-04-13 20:31:45
Since the cheap price was good
Engine parts Measurement
On 2016-02-25 14:33:55
When the depth gauge of the vernier caliper is shifted by 0.2 mm initial value, but is what was reported last time, then, there was no problem when I make sure well. Little was too hastily. I apologize to you.
On 2016-02-04 23:51:56
☆ It is not inferior and first-class manufacturers use in the factory. It is sufficient for use in not necessary work of precise accuracy.
Used for a variety of measurements. Outside, it is what must be on the inner measurement.
On 2015-12-17 23:05:57
But it should be buy a little more large size. Since the 5 centimeter had short ones.
Measurement of parts, etc.
On 2015-12-09 17:32:22
Play compared to certain brand item? Backlash? I felt the question in greater accuracy. It would be unsuitable for the measurement of the precise ones, but such simple measurement remaining measurement and are used simplistic because the problem is unlikely.