The reviews are automatic translation.
End face groove processing
On 2017-01-05 21:11:45
I want a byte [44-inch] the chip is riding on the opposite of this
On 2016-11-28 07:26:11
It is a little more want thicker the chip. In order to put the strength
On 2016-01-12 16:25:24
Than the bench lathe accessories of carbide chips byte, it shaved well.
Blade width was sharpening yourself to 2mm.
45C SCM435 (A material) cutting-off (mini lathe)
On 2015-11-03 21:31:48
Select the ST110.
Since the low of the root lathe rigidity is stingy until 2mm has dropped the width.
Price is just good for the practice of sharpening so appropriate.
Parting, grooving in the 3 feet lathe
On 2015-09-22 23:35:13
Since there is no one of the same size in the Sanwa was purchased here. Because I not felt the difference in the quality of both the manufacturers in large size, after the price of the issue. Usage of the problem is not nothing, you can buy with confidence.
On 2013-05-29 20:24:38
It was bought in Toko which was under contract until now, but it was the price of about twice.
Well really grateful because it uses.
Also I want to buy immediately. We do that!
The cutting-off of a tabletop lathe
On 2012-10-21 23:47:25
Cutting edge angle is subtle but can be used without problems.
Since the shank height there is no thing of 9.5 or less
Since the cutting edge in the C2 lathe desktop becomes much more on the center of the Setsuzai
It uses by cutting the shank does not come out particular problem.
Bytes of about 8x8 for bench lathe for the prototype is also thankful when the lineup.
Since complete byte is such that there is 8x8 also consider there of purchase.
Such as cutting of brass or stainless steel
On 2012-09-11 23:53:05
It also cheap price, nor a cheap and irresponsible to say product, I use a stainless steel cutting in the cutting and slow speed of brass.
When you off guard and cracked or missing chip, but you can use sufficient to moderate the speed and feed. It is one that can be used with confidence cheaper.
On 2012-01-24 12:53:05
It could be commonly used.
On 2012-01-17 15:19:28
Or lathe is wrong, I do not know how to use that bad I am a lathe beginner. Blade source will break soon. To cut the round bar three φ30 we were folding two this byte. Than blade source of the shank is weak with respect to the width of the cutting edge?