The reviews are automatic translation.
On 2017-04-18 23:30:11
In reverse direction 44-3 of 43-3 it seems that manufacturers will not accept orders only in 10 units, Monotaro says 10 ten 20 pcs 30 pcs and make manufacturers to sell in 1 unit There is enough order I think
End face groove processing
On 2017-01-05 21:11:45
I want a byte [44-inch] the chip is riding on the opposite of this
On 2016-11-28 07:26:11
It is a little more want thicker the chip. In order to put the strength
On 2016-01-12 16:25:24
Than the bench lathe accessories of carbide chips byte, it shaved well.
Blade width was sharpening yourself to 2mm.
45C SCM435 (A material) cutting-off (mini lathe)
On 2015-11-03 21:31:48
Select the ST110.
Since the low of the root lathe rigidity is stingy until 2mm has dropped the width.
Price is just good for the practice of sharpening so appropriate.
Parting, grooving in the 3 feet lathe
On 2015-09-22 23:35:13
Since there is no one of the same size in the Sanwa was purchased here. Because I not felt the difference in the quality of both the manufacturers in large size, after the price of the issue. Usage of the problem is not nothing, you can buy with confidence.
On 2013-05-29 20:24:38
It was bought in Toko which was under contract until now, but it was the price of about twice.
Well really grateful because it uses.
Also I want to buy immediately. We do that!
Cutoff on a desktop lathe
On 2012-10-21 23:47:25
The angle of the cutting edge is subtle, but it can be used without problems. Since there is nothing with shank height of 9.5 or less, since the cutting edge is far far above the center of the workpiece on the desktop C2 lathe, it does not cause problems, although it is being used by shaving the shank. I am thankful that a line of 8 x 8 bytes will be available for a prototype table turning lathe. It seems there is 8x8 in the complete byte so we will consider buying it as well.
Cutting of brass and stainless steel etc.
On 2012-09-11 23:53:05
The price is also cheap and it is not a somewhat commodity even if it says cheap, I use it for cutting of brass and cutting at low speed with stainless steel cutting. Chipping or cracking will result in chipping or cracking, but you can use it if you adjust the speed and feed. It is a cheap and safe to use one book.
On 2012-01-24 12:53:05
I could use it normally.