Master Carbide Bar, Coating C Series CB2C105TG
- Package Qty.
- Ship pack of
- Recommended Rotation Speed (min-1[r.p.m])
- Brazing type
- Shank Length (mm)
- Blade Length (mm)
- Blade is split off by a cross-cut, each cutting edge, easy to handle because the chip is divided small. Film layer formed on TiN (Titanium Nitride) coated carbide bar surface low coefficient of friction and increases the hardness.Chips with a brush imp
- Blade Diameter (phi mm)
- Cut Name
- Master cut
- Shank Diameter (phi mm)
- Carbon and alloy steel, heat-resistant steel, stainless steel, cast iron
Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
2 Customer Reviews
The reviews are automatic translation.
Spiral is difficult to use
On 2017-07-20 11:24:23
It is a locksmith. I use it to destroy some things. Spiral is big eyed so it gets caught strongly soon and it is hard to use. I will recommend a mesh "master cut". It is written that it was good that the other person should be spiral, but it was written in reverse. Be careful.
On 2016-04-06 18:53:42
Because the eyes are big, it hangs strongly and the rotation stops. Because it was lacking several blades in one use, life expectancy may be it is regret that it was good if it had to do to spiral cut.
Customers Who Bought This Item Also Bought