The reviews are automatic translation.
Copper pipe processing
From Japan
On 2014-01-15 10:37:40
Even when bending it to 180 degrees it did not crush into the pipe and it was finished neatly. Processing of the pipe affects the function of the product so it was right to purchase it.
Used to make grease piping with copper pipe at work
From Japan
On 2013-05-22 18:54:01
Very easy to use and satisfactory in terms of cost. If I say greed, it is best if several pipe diameters are bent at this price but ... I think that it is not necessary to buy a vendor that is quality enough and expensive.
Maintenance work of cars, mainly large vehicles
From Japan
On 2012-03-09 21:03:42
I am using it for the brake pipes and air pipes of cars. It is easy to handle and easy to use.
Copper tube bending
From Japan
On 2011-12-09 12:21:58
At the time of grasping the copper pipe first, since it does not become perpendicular to the core of the tool, it is necessary to know how to read the dimension and how to read the angle scale. It is not so painful if you get used to it, but please be careful if there is no room in the material. I think that I will perform the minimum work for the item price.
I bent 1 x 10 mm pipe to 90 ° and 45 °.
From Japan
On 2011-11-02 07:42:53
Is it only my purchase? Is it a defective item? Both 90 ° and 45 ° have uncorrectable dented scratches by stoppers. The reason is that the pipe clasp on the fixed side (the one with the circular scale) is cut at right angle and I want to return it without being usable in this state unless it cuts the corner corresponding to the pipe round like the right hand side.
Bending of ordinary annealed copper tubes and aluminum tubes
From Japan
On 2011-07-25 23:06:30
It can be used as well as other products. It is necessary to align the vendors according to the required aperture, but it is easier to handle than the one that supports multiple calibers. It does not cause scratches during bending, and it can be used normally. I have never tried a stainless steel pipe.
Fold the tube for the outfit of the pleasure boat.
From Japan
On 2011-07-02 08:49:42
Bending work of the aluminum pipe was done well. I thought that it would be possible to deal with stainless steel pipe.
Bending process of pipe
From Japan
On 2011-04-06 13:02:37
Even a slightly hard material could be easily bent. This cost performance is attractive as it is only used occasionally.
I am using it for bending 8 millipipes of suspension 304/316
From Japan
On 2008-06-18 04:36:41
I wanted to buy Impe, but good things are stolen so it's a big right answer. If anything makes the grip blue, the appearance will also be impressive ...