The reviews are automatic translation.
On 2017-05-22 18:00:42
Although it may be a monotary product, it is small in size. So, I made it to this. Because it is cheaper than group tapping.
Metal parts processing
On 2016-11-18 09:43:10
In self-made T-slot nuts, it was purchased in order to cut the blind screw.
M10 is I thought whether painstaking, but well threaded itself also emissions of Chirico was very satisfied with the good sharpness, the scope of the incomplete thread portion of attracting was a 5-star if a little more narrow.
Threaded to the radio control of the self-made aluminum servo horn
On 2015-07-29 08:41:05
The width of the chips relief there is also anxiety because the large relative to the diameter of the tap, the thickness of about width 3mm, in this 2mm tap is open pilot hole 1.6mm in the 6000 series aluminum plate, one that does not cut even one screw the lowest product and would break in. Given the time and effort to remove the cutting edge that caught in the small hole, but better better to cut out one more component is defintely, also in DIY work of leave to much free time, individual manufacturers of goods do not want to buy again. This is honest impressions.
Tapping to the SK material
On 2015-03-04 22:33:15
Although faceted Product Description There was to be discharged on the Well is somewhat to the return it will be collected in the groove, but I have pluck. Who YAMAWA of spiral tap that has been used before for this product (non-coated product) was thought to was good.
Stainless steel lathe tapping
On 2014-05-07 12:40:47
It was sharp and good for the stainless steel material without occurrence of muscle etc. It was about 50 processing, so I would like to try it again at the next mass production.
On 2011-02-23 19:33:58