Carbide Lathe Center MT2x60deg
Ship pack of
Used with lathes to eliminate deflection and vibration of processed products.
Overall Length L (mm)
Tip Point Diameter (mm)
Dimensions D (mm)
Point Angle (Degree)
Point super-hard chip
Outer Diameter (phi mm)
Customers Who Viewed This Item Also Viewed
4 Customer Reviews
The reviews are automatic translation.
Used on a table lathe
On 2014-01-10 08:37:11
It is too much spec for a desktop lathe. If you have a carbide and you can make a race center of 50 extra length, we will repurchase.
Stability of long bar in lathe operation
On 2010-12-06 13:31:41
It is unknown about durability because it was only used a little. I think that there is little core shake.
On 2010-04-30 23:27:24
Although the accuracy was not fluctuating and there was no problem, after the accuracy check, the round bar processing of SS400 began, since it ran out after about 5 minutes, the center was confirmed, the carbide part was missing. I just planned to make a die holder, so now I am using it as a shank of the die holder.
Use in lathe
On 2007-12-11 13:59:11
Because I can not swing because it is cheap, I use it with confidence.
Customers Who Bought This Item Also Bought