The reviews are automatic translation.
On 2014-08-04 19:02:41
It was stable and very easy to use.
Attaching door visor in cold season etc ...
On 2014-02-08 17:35:44
I am satisfied with the highest power.
Seal peeling, Envi pipe adjustment, Envy welding
On 2014-02-04 22:25:45
It is better to change the temperature · It is better to change the air volume, just do not you have to cool by blowing after using it at high temperature? There is no blast. I would like to use it for welding PVC, but is there a thin nozzle?
Used for installing vinyl chloride sheet on third order curved surface
On 2013-12-20 15:44:38
I think that it is very good to be able to perform strong air blow and temperature adjustment. Improvement point is because the position of the switch is inside, so it is difficult to do the on and off operation, I think that the operability will be better if it becomes possible to adjust with the thumb.
Formation of bag dough
On 2013-03-25 09:34:35
Previously, heating work which had been done with a commercially available hair dryer could not produce high heat, but it became easier to work because it can be freely adjusted to 50 to 550 ° C.
On 2013-02-05 11:56:24
It is even better if you can adjust the air volume in addition to the temperature control, but if it is from this price it is this level ... It is up to the rice cake.
Heat shrinkage and carbon prepreg molding
On 2012-10-04 23:25:45
The temperature adjustment is very convenient, the price is also cheap. In my case, the air volume is just right.
On 2012-03-20 17:08:25
Because the wind speed is slow (weak), the working time has been extended. I hope the rest will not break.