The reviews are automatic translation.
On 2016-09-29 18:58:00
ON OFF is a little stiff. ok because in spite of this small magnetic force was stronger
Attach the jig Toka bracket for small work to M5 Tap to work with adsorption on top of the iron stand. For example, it is convenient to use, such as the soldering of printed circuit boards.
On 2016-05-03 19:45:08
Adsorption force is a very powerful, easy to use because the small size, I am satisfied.
On 2015-12-16 14:58:33
Easy-to-use compact. It can also be used in a narrow place
Accuracy measurement of machine tool
On 2014-09-14 22:53:30
Finish of the seat also is Nashi adsorption force is also a problem of the magnet.
I think that's the best is as cost-effective.
As a pedestal for fixing the work of the engraving machine
On 2013-12-24 10:12:23
M5 screw holes is available up to a depth of about 5mm, the magnet will be locked in and tighten it more. In effective thread depth, so troubled when you buy, I think that good and you are able to display in advance. (On our side of the intended use, but was a result OK,)
In addition, not only the lower surface, the back is also a valid ON-OFF of the magnet, it was perfect for this time of use applications.
On the other hand, does not use more than a few days, two of four in the display nameplate of ON-OFF has over peeled off from the upper-right corner. Paste degreasing before processing it seems insufficient. In addition, even in easily peeled off the corner by reducing the nameplate just a little bit, I think that it also eliminated that, such as a finger touches. I hope to improve.
On 2013-06-20 10:53:14
Price is reasonable. Leading manufacturer product is I think quite expensive because the frequency of use, may be selected to use location.
As typical of the temporary fixing of compact equipment
On 2013-06-06 22:57:41
Fixed base of LED lighting, use the temporary stop such as hear mounting. Too large and it is usually of the magnet, it is inconvenient to carry, but will come in handy at a reasonable size.
Sheet metal welding
On 2012-04-13 14:30:56
It is using the positioning at the time of welding (1.0 to 4.5 spc). Remove After tacking to. The strength of the magnetic force is also easy to use, I like because it is switched on and off. We in conjunction with the not a mini. It is also recommended to the price basis.
Fixing of the welding work
On 2012-04-02 16:08:13
Adsorption force might be nice if a little strong, but it is not perfect for the time being.
Work tool for shipyard
On 2012-01-11 13:01:20
We hope that the reduction of the magnetic force due to heat is less compared to conventional magnet.
Still, it is a state that is not be determined until either there is an effect of how much has just started using.
If a full-fledged use, it will be several hundred is a need, we are expecting.