Taper pin reamer TPR040
- Package Qty.
- Ship pack of
- Wide Diameter D2 (mm)
- Blade Length l (mm)
- Point Angle (Degree)
- TRUSCO Part Number
- Standard Length a (mm)
- Blade Diameter D1 (mm)
- Shank Diameter d (phi mm)
- Overall Length L (mm)
- Number of Blades
- MCO (cobalt high-speed steel)
Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
5 Customer Reviews
The reviews are automatic translation.
Adjustment of the fitting hole
On 2017-01-15 13:06:49
Not the original use, but it is used to adjust the holes fit.
On 2016-05-31 14:35:02
None in particular impossible without also acceptable
The reamer work
On 2015-09-07 22:00:35
Used to the reamer work by hand.
Accurately a beautiful hole was bored.
About S45C is the limit if do by hand, but you finish to clean if the hardness of up to S45C.
Is adjusted fit in kind aligned with the axis of a hole in the Kiri in bamboo
On 2015-06-23 17:54:58
While using the handle for the tap, the fingers of your right hand is for applied to the large diameter side of the blade, are used by the Kaga to the blade with tape. Or you can not increase the length of the no blade of the knife? ? ?
To make a hole in the paper, we make a thin tool of cylindrical as punch.
Shaved the inside to taper has been used to smooth.
On 2009-09-01 23:50:45
I think if there is a tapered reamer from the more narrow 0.4.
Customers Who Bought This Item Also Bought