Taper pin reamer TPR500
Ship pack of
Point Angle (Degree)
Blade Diameter D1 (mm)
Shank Diameter d (phi mm)
Overall Length L (mm)
MCO (cobalt high speed steel)
Wide Diameter D2 (mm)
Blade Length l (mm)
Customers Who Viewed This Item Also Viewed
HOZAN TOOL INDUSTRIAL CO.,LTD.
5 Customer Reviews
The reviews are automatic translation.
Adjust fitting hole
On 2017-01-15 13:06:49
Although it is not the original usage, it is used to adjust fitting holes. very convenient.
On 2016-05-31 14:35:02
Especially not possible nor impossible
Reamer for work
On 2015-09-07 22:00:35
Used when doing reamer work by hand. A beautiful clean hole was made. It is the limit if S45C degree is done by hand, but if it is hardness up to S45C it will be beautiful finished.
I pierce the bamboo with holes and adjust the fits according to the actual thing on the shaft
On 2015-06-23 17:54:58
I use a handle for tapping, but since the finger of the right hand hangs on the large diameter side of the blade, I use the tape with a scratched blade. Can you lengthen the length of the part without the blade? Is it? Is it?
In order to make a hole in the paper, I make a cylindrical thin tool like a punch. It is used to smooth the inside by tapering it.
On 2009-09-01 23:50:45
I think that there is a taper reamer from 0.4 more thinly.
Customers Who Bought This Item Also Bought