The reviews are automatic translation.
On 2017-01-03 22:11:09
Whether the system is the slightly larger than φ4, does not go to the spindle of the CNC lathe you are using.
Plastic model during production
On 2016-08-09 18:14:30
Attached to the hand of Ryuta we use to process and the like of the plastic model.
Only in sharpener sharply indeed carbide end mill, it has been careful not too sharpener to reverse.
On 2014-10-16 15:58:01
End mill is heard rumors that can be used in the router, I saw bought. Since finished in a very beautiful, it is satisfaction.
Aluminum A6061 cutting
On 2014-03-26 16:36:06
Depth 5mm groove carved in φ6mm. Easily broken in a state that does not proceed 10mm.
Whether the conditions of speed and feed rate was bad, but too brittle.
Manufacturers of high-speed steel end mills under the same conditions have been the work of a few hundred times without falling even sharpness.
Hole repeat the finishing touch
On 2012-04-23 20:53:08
It finished in a clean
On 2012-04-17 23:19:27
But so also other milling tool, but,
Accuracy can greatly satisfied with the same goods and the same level of other companies.
Because the place that does not change even wear will continue buy at this price.
By all means we want you to set the 7mm.
Used in woodworking for trimmer
On 2011-12-02 22:30:52
Spiral bit of trimer price was used as a spiral end mill for expensive.
Straight bit came out burrs, but it was clean shaved in the end mill 4 flute.
Feed is going to be without the use of smooth for straight.
Use the cut-out in the woodworking router
On 2011-05-25 20:59:53
Cut and finish is satisfactory. Best if the blade length of 25mm or more.
Be left blade length is now, full-length I should longer at least 5mm.
It might be wrong to use as a spiral bit for woodworking.
On 2010-01-28 20:19:16
Trial purchase. Although reasonably available, cutting performance felt Nari price.
We're using the cutting of the bolt holes in the deep.
On 2010-01-24 23:55:05
It also uses the aluminum cutting. Because it is four-blade position also Hakadori work so stable cutting can be.