The reviews are automatic translation.
Hole drilling of stainless
On 2016-11-20 04:42:38
I think that there is no way because it is reasonable but price is a little frustrated because you did not so much because it was M3 and thin tap long-lasting
Control panel production
On 2016-03-07 19:21:39
In Monotarou where the spiral tap of home improvement had been puzzled to buy expensive
Purchase I found something affordable. Cost performance is good because for the time being is can be used normally.
On 2014-08-12 22:51:13
SKD11 broke immediately on trying to Arise the tap on the first one eyes.
On 2014-02-19 16:41:41
It was purchased because I had to cheap, but complaints from the scene of the break often.
Thing with useless. Is it a cheap and nasty?
I think that was purchased because it is usually of the half, had all returned goods when I bought at the normal price.
It should be in the early Discontinued.
Old car restore muffler - the time of the exhaust system maintenance
On 2013-05-13 19:01:43
Well off. When you use crowded Grease to advance dent part, it can be retrieved to catch a cutting powder.
It has really helped.
I tried to trial in SCM435.
On 2012-08-08 12:08:17
M6 and tried to compared opened under the same conditions as the OSG does become a story.
MonotaroTAP was superb break in the one-hole eyes.
OSG has drilled more than 100 holes, but did not break.
Really Is that possible metal processing?
It does not have an established product.
Was purchased only one in the trial is the salvation.
I do not want to use is this anxiety tool in the final step.
I think that as soon as possible is better to consider the quality improvement.
I will not buy until then.
On 2012-08-05 16:49:18
This soon relent? Never tap saw until now crumbling.
Three in a row. A new article.
Fortunately broken taps was caught.
Both three. So like a load on the tool itself is not at stake.
I do not already purchased absolute.
Tapping to the iron
On 2012-02-24 20:24:28
Clearly weaker than the name brands.
Use the swivel
On 2011-12-20 12:33:26
Problem is not.
Tapping of the machining center
On 2011-11-28 15:23:43
Since the M6 was good tone, but I tried to purchase also M8, screw does not start at all is working safety device of Tupper. Than there is a serious flaw in the manufacturing process?