The reviews are automatic translation.
Used for compressor relay
On 2018-05-13 15:36:53
There is nothing wrong and I use it normally. I think it's good.
Redrawing the lathe electrical circuit
On 2018-05-12 15:08:03
I reworked the old lathe electric circuit. Originally Fuji Electric's items were attached, so we made it Fuji's product again this time. I hope I can use it for a long time.
When checking and servicing equipment
On 2018-04-18 11:56:35
It is a stable product with a safe brand item. I am satisfied with the price as well.
Equipment panel internal parts, for replacement
On 2018-03-07 11:23:29
It is a general magnetic contactor.
Consideration must be given to the cooling method when peroxide and sulfide are contained in the atmosphere to be used.
There is no case to use the auxiliary contact, so it is better if we can downsize or increase the opening / closing capacity or incorporate the surge suppression element ... etc.
Repair of plastic molding machine
On 2018-01-13 13:27:02
I bought it this time because I think that there is no expensive thing if I purchase it with Monotaro at the procurement of repair parts inside the company.
Of course I can use it without problems.
On 2017-12-20 00:45:28
It was a relay of the same part number attached to a compressor with less use frequency, but it was broken in 6 months.
Used for power-on circuit
On 2017-11-17 16:29:31
It was the performance I expected. Since it is a product of a first-rate enterprise, it can be used with confidence.
On 2017-10-29 10:05:24
I bought it to raise and lower the table lifting and lowering the table of the sewing machine used for 26 years. If you purchase for raising and lowering If you buy one set of reversible type you will not draft the wiring diagram dramatically but I think that the exchange work will be easier with a simple wiring diagram draft.
On 2017-10-26 09:13:47
I exchanged the table for the sewing machine being used for 26 years for raising and lowering the floor tightening. Quite a bit of contacts were exchanged and it was correct.
For motor driven switches
On 2017-10-03 19:45:05
There is no problem in particular. I am using this because I am always used.