The reviews are automatic translation.
On 2014-10-11 13:48:52
It is good.
After iron / stainless steel drilling
On 2014-07-25 16:30:08
On 2014-05-17 22:20:16
Hand is full of oil
Deburring after the aluminum products processing
On 2014-03-26 13:30:53
Without any problem is to use
I want you because instruction manual want a simple copy
During the cutting operation
On 2013-11-20 13:11:19
Until now had over a fine time to prep Bali, this good work can be.
Price can also be convinced.
Chamfering, when you want to spread large in drilling work
On 2013-10-18 18:45:33
I use immediately from the time they arrived. It is convenient can also be used in both left and right. Because it is a little difficult to use is to cut the plastic, such as bumpers, please develop a Plastic.
Used in the meal of 45C and 303
On 2013-08-29 13:08:05
The cost performance outstanding. It has than domestic chip.
Aluminum machined surface of deburring
On 2013-06-25 16:24:10
Since it is kind is also a wealth of axial length adjustment of the blade, it has come in handy to be able to easily processed in an easy stance to do of their own. The price of the split was felt that there is a high quality.
Normal of deburring work
On 2013-03-25 10:13:56
I think that it is enough to CP basis.
The outer diameter of lathing, used when pulling the end face
On 2013-02-21 20:04:02
Chip that has been used until now, will be discontinued, I bought the holder and the chip of Monotarou. Cheap on the earlier, more than those that have been used, clean the sink, you have may be because the are also coated.