Buy more than* S$200* and get FREE SHIPPING
Due to the national holidays as Golden Week, we will close 2018/4/28~2018/4/30 and 2018/5/3~2018/5/6.
This may cause delays with our responses. Thank you for your understanding.
It is in a wooden case for reasons of low price, and even if it actually looks at the commodity it is comparable to the leading manufacturer. Even if it is used, it is no different from the manufacturer. I think that it is a good product.
When scribing the dimensions on the plate material, we use the depth of the gauge as a distance from the board
On 2012-02-24 00:08:19
In the flat wing which becomes the starting point of the depth, since the central part is about 1 mm down about 10 mm, if the width of the plate is narrow, it will not be used. If you use it as a normal depth gauge, you can not measure the depth if there is not enough surface to be the same. I think that other manufacturers have the same structure. It seems not to be a thing to increase precision or to say that the part has to be lowered by design inevitably, but it is mysterious because it is down as normal.
It is used for measurement of turning of turning lathes etc. and depth measurement of various things. Until now I measured with the depth of the calipers but since the ground plane is small, the caliper blurred, I could not feel relieved anyhow, but this is still only for exclusive use, the ground plane is stable and accurate measurement can be done I will. It is also a caliper, but the movement of low-priced items is bad is also here. I think that it is a satisfactory commodity from the price if you do not need good things with less frequency of use like a caliper.