The reviews are automatic translation.
When the machine is assembled
On 2016-06-14 05:49:45
The bearing portion of the rotating part
On 2016-05-03 13:52:48
To somewhere, Katazuke on now missing, do not use yet, also when it is necessary, again order.
Bearing exchange repair of the pulley.
On 2016-03-15 07:22:03
Since the pulley which is in a high place, in use it is happy to go without lubrication.
On 2016-01-20 19:30:38
In quality good.
Bearing of the self-made bicycle brake
On 2015-10-07 01:23:45
We did going to make from a round bar of phosphor bronze, look at this price, better to buy it was determined that good.
We are using up and down the slide bearing.
On 2015-08-10 19:32:12
Smooth shaft will be saved without trouble up and down the slide.
Bike swing arm of
On 2015-05-16 15:04:49
Accuracy is also good, price was good very cheap.
Some material is soft, but slightly after the press has become the tight clearance, it is a grade that can be fixed in the sandpaper.
Bike swing arm bush
On 2013-11-12 21:45:28
Replace it with a plastic bush of the swing arm mounting portion of the bike.
Although it was the needle bearings use plan was attached to change in the bush there is no size, but not a problem to the movement.
Satisfaction because the strength is also high likely than even in comparison with the resin's a smooth needle bearings.
While standing more than two months there is no trouble so far after installation.
I want also to use next time.
Used as an alternative to part of the old bike
On 2013-07-16 14:27:27
It is very common. There is no special impression.
Because of the shaft running, as a bearing
On 2013-06-19 13:21:09
Than bearing, movement is also smooth, so where consuming load, has been running well.